|
1.Before inspection, set the
vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch
to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 -
Precautions Before Service - M.U.T.-III Sub Assembly
).
|
![](../../../img/11/AKB00552AB00ENG.png)
|
3.Set the timing light to
the power supply line (terminal No. 3) of the ignition coil
No. 1.
note |
The power supply line is
looped and also longer than the other ones.
|
4.Start the engine and let it run at
idle. 5.Check that ignition timing is at the
standard value. Standard value: Approximately
8° BTDC 6.Check the idle
speed. Standard value: <Except
vehicles for Thailand>
M/T: 700
± 50 r/min CVT: 750 ± 50
r/min
<Vehicles for
Thailand>
note |
- The idle speed is controlled
automatically by the idle speed control
system.
- When using the M.U.T.-III, select item
No. 2 and take a reading of the idle
speed.
|
7.If the idle speed is outside the standard
value, inspect the MPI system (Refer to GROUP 13A -
Troubleshooting - Inspection Chart for Trouble
Symptoms ). 8.Remove
the timing light. 9.Turn the ignition switch to
"LOCK" (OFF) position and then disconnect the
M.U.T.-III.
|