![](../../../img/11/AK901146AD00ENG.png)
|
Install the water pipe gasket as
its protrusion is in the direction shown.
|
![](../../../img/11/ACB05737AB00ENG.png)
|
Make sure that the marking on the
hose should face towards the transmission.
|
![](../../../img/11/AK304916AB01ENG.png)
|
Install the thermostat onto the
cylinder block such that the jiggle valve is positioned on
top of the thermostat housing.
|
![](../../../img/11/AK400587AD00ENG.png)
|
1.Remove any sealant that
may be remaining on the engine coolant temperature sensor or
the threaded hole in the cylinder head. 2.Apply
sealant onto the threaded portion (illustrated) of the
sensor. Specified
sealant:
LOCTITE 262 or
equivalent
3.Install the engine
coolant temperature sensor onto the cylinder block by
tightening it to 30 ± 9 N·m.
|
![](../../../img/11/AK901147AB00ENG.png)
|
1.Remove any sealant that
may be remaining on the angle sensor or the mounting face on
the cylinder block. 2.Apply a bead of sealant with
a diameter of 1.7 ± 0.5 mm on the cylinder block as
illustrated. Specified
sealant:
ThreeBond 1207F or
equivalent
3.Install the crank
angle sensor onto the cylinder block by tightening it to 9.5
± 2.5 N·m.
|
![](../../../img/11/AKB00479AB00ENG.png)
|
Align the detonation sensor
connector with the position shown in the illustration, and
then tighten it to the specified torque of 20 ± 2
N·m.
|
![](../../../img/11/AK402699AB00ENG.png)
|
1.Remove any sealant that
may be remaining on the engine oil pressure switch or the
threaded hole in the cylinder block. 2.Apply
sealant to the threaded portion of the engine oil pressure
switch as illustrated. Specified
sealant:
ThreeBond 1215 or
equivalent
3.Install the engine
oil pressure switch onto the cylinder block by tightening it
to 10 ± 2 N·m.
|