|
1.Move the selector lever to
the N range.
|
|
2.Loosen the adjusting nut
so that the manual control lever moves freely.
|
|
3.Move the manual control
lever to Neutral position.
|
![](../../../img/23/ACB05800AB00ENG.png)
|
4.Loosen the inhibitor
switch body mounting bolt, and turn the inhibitor switch
body so that the hole in the inhibitor switch body flange
aligns with the hole on the end of the manual control lever
(section A - A on in the figure shown left).
note |
Insert a Φ5 bar into the
aligned holes in the inhibitor switch body
flange and on the tip of the manual control
lever to position the inhibitor switch body.
|
5.
caution |
Be careful that the inhibitor
switch body does not move out of the
position.
|
Tighten the inhibitor switch body mounting bolts to
the specified torque. Tightening torque: 5.9
± 1.0 N·m
|
![](../../../img/23/ACB04728AC00ENG.png)
|
6.
caution |
- Confirm that the width across flats of
the cable end, matches a long hole of
manual control lever.
- Before assembling between a manual
control lever and an cable end of
transmission control cable, release
taking a hold on an cable end once, and
it’s surely confirmed that it
doesn’t take tension on.
|
Use the adjusting nut to tighten the transmission
control cable to the specified
torque. Tightening torque: 9.5 ± 3.5
N·m 7.Make sure that the selector
lever is in the N range. 8.Make sure that the
transmission-side ranges that are corresponding to the
selector lever position operate and function without
fail.
|