|
|
After the CVT assembly is replaced,
learned values must be initialised. The initialisation
procedure is as below.
|
|
|
1.Move the selector lever to
the P range and turn the ignition switch to the LOCK (OFF)
position. Then, connect M.U.T.-III to the diagnosis
connector.
|
|
|
2.Turn the ignition switch
to the ON position, and then move the selector lever to the
R range.
|
|
|
3.Depress the accelerator
pedal while depressing the brake pedal. (Engine stops.) Use
the M.U.T.-III special function to execute
"reset (item No.3: C/V initial & learned value)"
while holding them in applied position.
|
|
|
4.Set the selector lever to
the P range.
|
|
|
5.Turn the ignition switch
to the LOCK (OFF) position, and then wait for ten
seconds.
|
|
|
6.
| caution |
Do not start the
engine.
|
Turn the ignition switch to the ON position, and
then wait for ten seconds.
|
|
7.Check that "P" is
displayed on the selector lever position indicator on the
multi-information display.
| note |
"P" will disappear while the
data is being read. "P" will appear when the
data reading is complete.
|
8.Turn the ignition switch to the LOCK (OFF)
position and then to the ON position. Then use the
M.U.T.-III to erase the CVT fluid degradation
level.
|