![](../../../img/23/ACB04726AF00ENG.png)
|
While pressing A in the figure,
turn B anti-clockwise to unlock the CVT assembly connector,
and disconnect the connector.
|
|
Only loosen the bolts from the
engine and transmission assembly (do not remove).
|
|
1.Remove the coupling bolts
while turning the crankshaft.
|
|
2.Fully push the torque
converter into the transmission side so that it does not
remain
on the engine side.
|
![](../../../img/23/ACB04320AB00ENG.png)
![](../../../img/23/ACB04321AB00ENG.png)
|
1.<When engine hanger
(Special tool: MB991928) is used> (1)
Assemble the engine hanger (Special tool: MB991928). (Set
the components
below to the base hanger.)
- Slide bracket (HI)
- Foot x 4 (standard) (MB991932)
- Joint x 2 (50) (MB991929)
(2)
Set the foot of the engine hanger (Special tool: MB991928)
as shown in the figure.
|
note |
Adjust the engine
hanger balance.
|
|
(3)
Remove the garage jack and then remove the transmission
assembly upper part coupling
bolts that have been loosened previously.
|
![](../../../img/23/ACB04322AB00ENG.png)
![](../../../img/23/ACB04323AB00ENG.png)
|
2.<When engine hanger
(Special tool: MB991895) and engine hanger
attachment (Special tool: MB992906) are used> (1)
Set the foot of the engine hanger (Special tool: MB991895)
and engine hanger attachment
(Special tool: MB992906) as shown in the figure.
|
note |
Adjust the engine
hanger balance.
|
|
(2)
Remove the garage jack and then remove the transmission
assembly
upper part coupling bolts that have been loosened
previously.
|
![](../../../img/23/AC209056AB00ENG.png)
|
Fully push the torque converter
into the transmission side, and then assemble the
transmission
assembly to the engine.
|