![](../../../img/23/ACB04726AE00ENG.png)
|
1.While pressing A in the
figure, turn B anti-clockwise to unlock the CVT assembly
connector, and disconnect the connector.
|
![](../../../img/23/ACB04727AB00ENG.png)
|
2.
caution |
Insert a thermometer which is
made of metal or is put in a metal case (overall
length: approximately 150 - 200 mm) into
the transmission case hole approximately 80
mm.
|
Remove the oil filler pipe assembly (Refer to
Transmission Assembly), and insert a thermometer into the
transmission case hole.
note |
If a radiation thermometer
(noncontact thermometer) is available, use it to
measure the surface temperature of the oil
pan.
|
3.Measure the resistance between the
sensor-side connector terminal No. 12 of the CVT assembly
connector and the earth (terminal
No.18). Standard value:
|
Fluid
temperature
(°C)
|
Resistance
kΩ
|
20
|
Approximately
6.5
|
40
|
Approximately
2.2
|
80
|
Approximately
0.9
|
|
4.
caution |
The CVT fluid temperature
sensor cannot be removed or replaced as a single
unit.
|
When the resistance of the CVT fluid temperature
sensor is outside the standard value, and the fluid
temperature warning comes on/goes out at other than
the specified temperatures, replace the CVT
assembly.
|