|
Support the front suspension
crossmember with a transmission jack, and remove the
mounting bolts of the front suspension crossmember. Then,
remove the front suspension crossmember assembly with the
steering gear and linkage installed.
|
![](../../../img/32/ACC02228AB00ENG.png)
|
The slit in the stabilizer bushing
should face towards the vehicle rear.
|
![](../../../img/32/ACC02229AB00ENG.png)
|
Position the identification mark of
the stabilizer bar at the left side of the vehicle as shown
in the figure, and tighten the mounting bolts to the
specified torque. Tightening torque: 23 ±
6 N·m
|
![](../../../img/32/ACC02121AD00ENG.png)
![](../../../img/32/ACB03472AE00ENG.png)
|
Install the steering shaft joint
dust cover so that the cover notch is aligned with the
projection of the steering gear and linkage
assembly. Shall fit the steering shaft joint dust cover
in steering gear and linkage assembly cater-corner, then fit
in all round until the lip shall be fitted into groove of
steering gear and linkage assembly. Shall pull the
steering shaft joint dust cover to confirm that the steering
shaft joint dust cover is fitted into steering gear and
linkage assembly securely.
|
![](../../../img/32/ACC02231AB00ENG.png)
|
Tighten the self-locking nut until
the stabilizer link thread part protruding length meets the
standard value. Standard value (A): 19 -
21 mm
|