![](../../../img/35/ACE00541AC00ENG.png)
|
1.Connect two pressure
gauges to the output port of the master cylinder and output
port of the proportioning valve. Tightening
torque: 16 ± 3 N·m 2.Bleed the
brake line and the pressure gauges (Refer to ).
|
![](../../../img/35/AC006222AE00ENG.png)
|
3.Depress the brake pedal
gradually. Then check that the split point, where the output
fluid pressure begins to drop in proportion to the output
fluid pressure, is at the standard
value. Standard value: 2.32 - 3.26
MPa 4.Depress the brake pedal more
strongly than at the above step. Then check that the output
fluid pressure is at the standard value when the input fluid
pressure is 6.37 MPa. Standard value: 3.13
- 3.94 MPa 5.Measure each output
fluid pressure at both valves, and check that the difference
between the two is at the limit value or
less. Limit: 0.5 MPa 6.If the
measured pressure exceeds the limit, replace the
proportioning valve.
|