REMOVAL AND INSTALLATION


<RHD>


caution The master cylinder cannot be disassembled. Be careful not to remove the primary piston.
Pre-removal Operation
  • Brake Fluid Draining
  • Air cleaner assembly Removal (Refer to GROUP 15 - Air Cleaner )

 Post-installation Operation
  • Air cleaner assembly Installation (Refer to GROUP 15 - Air Cleaner )
  • Brake Fluid Supplying and Air Bleeding (Refer to )
  • Brake Pedal Adjustment (Refer to )




Removal steps


1.
 Brake fluid level switch connector


2.
 Brake pipe connection


3.
 Pin


4.
 Reservoir cap


5.
 Reservoir filter


6.
 Reservoir assembly


7.
 Reservoir seal


8.
 Brake fluid level switch


9.
 Brake master cylinder assembly


10.
 O-ring


11.
 Brake vacuum sensor connector


12.
 Brake vacuum sensor


13.
 Grommet


14.
 Hose clip


15.
 Clip

>>A<<
 16.
 Vacuum hose (with built-in check valve)


17.
 Hose clip


18.
 Vacuum hose


19.
 Cable band


20.
 Vacuum pipe


21.
 Snap pin


22.
 Clevis pin
<<A>>
23.
 Brake booster assembly


24.
 Sealer

REMOVAL SERVICE POINT

<<A>> BRAKE BOOSTER ASSEMBLY REMOVAL
Disconnect the engine from the engine mounting. Lower the front of the engine to remove its.

INSTALLATION SERVICE POINT

>>A<< VACUUM HOSE (WITH BUILT-IN CHECK VALVE) CONNECTION


Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.