![]() |
2.Turn the bolt and knob to
make the special tool jaws parallel, then hand-tighten the
bolt. After tightening, check that the jaws are still
parallel.
|
![]() |
4.Operate the ball joint
stud to the right and to the left five times respectively,
and install the nut to the stud. Use the preload socket
(Special tool: MB990326) to measure the rotation torque of
the ball joint. Standard value: 5.0 N·m or less 5.If the measurement is greater than the standard value, replace the tie-rod end (Refer to ![]() 6.If any looseness or scraping feeling is experienced in the ball joint, even when the measurement is within the range of the standard value, the ball joint should be judged to be faulty. In this case, replace the tie-rod end (Refer to ![]() |