![](../../../img/42/AC103294AA00ENG.png)
|
1.Place an approximately 10
mm-thick wood board as shown. Then, close the door window
glass
by one-shot up action of the power window
switch. 2.Check that the window glass lowers by
about 150 mm when it clamps the board. This
is called anti-trap function (safety mechanism). If this
does not happen, carry out troubleshooting
(Refer to ). 3.Check
that the window glass continue raising up to the door upmost
position without
activating the anti-trap function while the switch is kept
pulling up (this is called forced closing
function).
note |
If the battery terminals are
disconnected or the fuse for power window is
removed, carry
out the learning procedures of the power window
fully closed position (Refer to ).
|
|