REMOVAL AND INSTALLATION

Post-installation operation

Door window glass adjustment (Refer to ).
Learning procedures of the power window fully closed position <Vehicles with safety system> (Refer to ).

		Door window glass assembly removal
	·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
	·	Waterproof film removal (Refer to )
<<A>>	1.	Door window glass assembly
		Power window regulator removal steps
	·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
	·	Waterproof film removal (Refer to )
	·	Door window rear lower sash (Refer to )
	·	Door window glass runchannel (Refer to )
<<A>>	2.	Power window regulator assembly
	3.	Power window regulator motor

note

For removal and installation of the power window switch, refer to GROUP 52A, Door trim

			Door window glass assembly removal steps
<<B>>	>>A<<	1.	Clip <Manual window regulator>
	>>A<<	2.	Regulator handle <Manual window regulator>
	>>A<<	3.	Escutcheon <Manual window regulator>
		·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
		·	Waterproof film removal (Refer to )
		·	Door window glass runchannel (Refer to )
<<C>>		4.	Rear door window centre sash
<<A>>		5.	Door window glass assembly
			Power window regulator removal steps
		·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
		·	Waterproof film removal (Refer to )
<<A>>		6.	Power window regulator assembly
		7.	Power window regulator motor
			Manual window regulator removal steps
<<B>>	>>A<<	1.	Clip
	>>A<<	2.	Regulator handle
	>>A<<	3.	Escutcheon
		·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
		·	Waterproof film removal (Refer to )
<<A>>		8.	Manual window regulator assembly
			Stationary window glass removal steps
		·	Door trim assembly removal (Refer to GROUP 52A - Door trim )
		·	Waterproof film removal (Refer to )
<<C>>		4.	Rear door window centre sash
		9.	Stationary window weatherstrip
		10.	Stationary window glass

note

For removal and installation of the power window switch, refer to GROUP 52A, Door trim

<Vehicles with power window>.

REMOVAL SERVICE POINT

<<A>> DOOR WINDOW GLASS ASSEMBLY/ POWER WINDOW REGULATOR ASSEMBLY/ MANUAL WINDOW REGULATOR ASSEMBLY REMOVAL

1.Remove the door window glass mounting bolts.

caution

If any film or the like is applied to a door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.

2.Lift the door window glass, and attach the special tool MB990480 to the glass as shown to prevent the glass from falling.
3.Remove the power window regulator assembly.

<<B>> CLIP REMOVAL

Use cloth to remove the clip as shown in the illustration.

<<C>> REAR DOOR WINDOW CENTRE SASH REMOVAL

1.Remove the door outer opening weatherstrip from the door centre sash only.
2.Remove the door centre sash mounting screws, and then remove the door centre sash from the door panel.

INSTALLATION SERVICE POINT

>>A<< ESCUTCHEON/REGULATOR HANDLE/CLIP INSTALLATION

1.Install escutcheon and regulator handle to the clip.
2.Close the door window glass fully, and then install the regulator handle as shown in the illustration.