TERMINAL VOLTAGE REFERENCE CHART




Terminal number
 Terminal code
 Check item
 Check condition
 Normal condition
1
 ANTG
 Immobilizer antenna output (-)
 When communicating with the keyless operation key (discharged battery) in the key slot
 0 to 5 V (pulse signal)
2
 LEDG
 Engine switch LED (green) ON signal
 Power supply mode: "ON"
 System voltage
3
 LEDW
 Engine switch LED (character illumination) ON signal
 Always
 System voltage
4
 EDRP
 Outside transmission antenna assembly (driver’s side) power supply
  • At the door switch operation
  • At the engine switch operation
  • At door open/close

 0 to 8 V (pulse signal)
5
 INFP
 Inside transmission antenna assembly (front) power supply
  • At the door switch operation
  • At the engine switch operation
  • At door open/close

 0 to 8 V (pulse signal)
6
 EASP
 Outside transmission antenna assembly (passenger’s side) power supply
  • At the door switch operation
  • At the engine switch operation
  • At door open/close

 0 to 8 V (pulse signal)
7
 INRP
 Inside transmission antenna assembly (rear) power supply
  • At the door switch operation
  • At the engine switch operation
  • At door open/close

 0 to 8 V (pulse signal)
8
 EGTP
 Outside transmission antenna assembly (trunk lid) power supply
  • At the door switch operation
  • At the engine switch operation
  • At door open/close

 0 to 8 V (pulse signal)
9
 ANTP
 Immobilizer antenna output (+)
 When communicating with the keyless operation key (discharged battery) in the key slot
 0 to 5 V (pulse signal)
10
 LEDA
 Engine switch LED (orange) ON signal
 Power supply mode: "ACC"
 System voltage
11
 PGND
 Earth (for CPU)
 Always
 1 V or less
12
 EDRG
 Outside transmission antenna assembly (driver’s side) earth
 Always
 1 V or less
13
 INFG
 Inside transmission antenna assembly (front) earth
 Always
 1 V or less
14
 EASG
 Outside transmission antenna assembly (passenger’s side) earth
 Always
 1 V or less
15
 INRG
 Inside transmission antenna assembly (rear) earth
 Always
 1 V or less
16
 EGTG
 Outside transmission antenna assembly (trunk lid) earth
 Always
 1 V or less


Terminal number
 Terminal code
 Check item
 Check condition
 Normal condition
21
 +B
 Battery power supply
 Always
 System voltage
22
 PCK
 Output of electric steering lock driving permission signal
  • KOS-ECU active
  • Engine stopped

 System voltage
23
 SGND
 Earth (for signal)
 Always
 1 V or less
24
 -
 -
 -
 -
25
 ST
 Starter output signal
 Cranking
 System voltage
Other than above
 1 V or less
26
 -
 -
 -
 -
27
 IG2
 IG2 output signal
 Power supply mode: "ON" (Without cranking)
 System voltage
Power supply mode: Other than ON
 1 V or less
28
 -
 -
 -
 -
29
 DRVB
 Output to buzzer (+)
 Buzzer is sounding
 10 to 12 V (pulse signal)
30
 DRRQ
 Lock/unlock switch (driver’s side) output
 Lock/unlock switch: "ON"
 1 V or less
31
 CLMS
 Clutch interlock switch ON/OFF detection signal
 When the clutch pedal is depressed
 System voltage
When the clutch pedal is released
 1 V or less (pulse signal)
32
 STP1
 Stop lamp switch ON/OFF detection signal
 When the brake pedal is depressed
 System voltage
When the brake pedal is released
 1 V or less (pulse signal)
33
 GTOP
 Trunk lid latch switch input
 Trunk lid: open
 1 V or less
34
 -
 -
 -
 -
35
 CANH
 CAN H
 -
 -
36
 -
 -
 -
 -
37
 IOD
 Power supply
 While the power supply fuse (IOD fuse) is removed, when the engine switch is pressed from the engine switch power supply mode "OFF"
 System voltage
38
 -
 -
 -
 -
39
 PCO
 Power control output terminal for electric steering lock
 Power supply mode: "OFF"
 System voltage
Power supply mode: Other than OFF
 1 V or less
40 - 41
 -
 -
 -
 -
42
 ACC
 ACC output signal
 Power supply mode: "ACC"
 System voltage
Power supply mode: Other than ACC
 1 V or less
43
 -
 -
 -
 -
44
 IG1
 IG1 output signal
 Power supply mode: "ON"
 System voltage
Power supply mode: Other than ON
 1 V or less
45
 SW1
 Engine switch ON/OFF detection signal
 When the engine switch is pressed
 System voltage
When the engine switch is not pressed
 1 V or less
46
 PDSW
 P position detection signal
 Selector lever: P position
 0 to 5 V (pulse signal)
Selector lever: Other than P position
 1 V or less
47
 -
 -
 -
 -
48
 GTRQ
 Trunk lid opener switch input
 Trunk lid opener switch: "ON"
 1 V or less
49
 SW2
 Engine switch ON/OFF detection signal
 When the engine switch is pressed
 1 V or less
When the engine switch is not pressed
 0 to 5 V (pulse signal)
50
 -
 -
 -
 -
51
 CANL
 CAN L
 -
 -
52
 LIN
 LIN bus line (local) for electric steering lock
 -
 -