|
The windshield wiper motor
assembly should be installed to the vehicle body and the
harness connector should be disconnected when checking the
wiper motor.
|
|
|
Connect the battery to the
windshield wiper motor to inspect the operation of motor
rotation at low or high speed.
|
|
1.Connect the battery to the
windshield wiper motor as shown in the illustration
(A).
2.Run the windshield wiper motor at low
speed, then disconnect the battery in the middle of the
motor rotation and check to see that the motor
stops.
3.Connect the battery to the windshield
wiper motor as shown in the illustration
(B).
4.Connect the terminals of the windshield
wiper motor connector as shown in the illustration
(B).
5.Check to see that the windshield wiper
motor runs at low speed and then stops at the automatic stop
position.
|
|
|
Check the windshield wiper switch
(mist, intermittent, low speed and high speed) from the
ETACS diagnosis codes for proper operations (Refer to GROUP
54A, ETACS  ).
|