REMOVAL AND INSTALLATION <VEHICLES FOR SINGAPORE>

Pre-removal and Post-installation Operation

Front Pillar Trim, Upper centre Pillar Trim, Rear Pillar Upper Trim Removal and Installation
Room Lamp Assembly Removal and Installation (Refer to GROUP 54A, Interior Lamp)

			Removal steps
		1.	Assist grip
		2.	Sun visor assembly
<<A>>		3.	Sun visor holder
<<B>>		4.	Headlining
		5.	Assist grip bracket
	>>A<<	6.	Pad (A)
	>>A<<	7.	Pad (B)
	>>A<<	8.	Pad (C)

REMOVAL SERVICE POINTS

<<A>> SUN VISOR HOLDER REMOVAL

Insert the special tools ornament remover (MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.

<<B>> HEADLINING REMOVAL

To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.

INSTALLATION SERVICE POINT

>>A<< PADS INSTALLATION

Use hot-melt or equivalent to attach the pads to the headlining so that the pads match the concave parts on the headlining.