REMOVAL AND INSTALLATION


warning
  • Never connect the negative battery terminal when the SRS-ECU is not installed securely. If you fail to follow this instruction, the air bag may deploy unintentionally, possibly causing a serious injury.
caution
  • Disconnect the negative (-) battery terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping the tape (Refer to the item 5 of Service Precautions ).
  • Never attempt to disassemble or repair SRS-ECU. If damaged, replace with a new SRS-ECU.
  • Do not drop or subject SRS-ECU to impact or vibration. If denting, cracking, deformation, or rust is discovered in SRS-ECU, replace it with a new one.
  • After deployment of the air bags, replace SRS-ECU with a new one.
  • When the SRS-ECU is replaced, chassis number writing and coding must be performed. Perform the coding when SRS-ECU sets diagnosis code No. U1195 (coding incomplete). Refer to the "M.U.T.-III operation manual" and perform coding.
Pre-removal operation
  • Turn the ignition switch to the LOCK (OFF) position.
  • Disconnect the negative (-) battery terminal.




Removal steps


·
 Floor console bracket front (Refer to GROUP 52A - Front Floor Console Assembly ).


1.
 SRS-ECU mounting bolt (earth bolt)


2.
 SRS-ECU mounting bolt


3.
 SRS-ECU mounting bolt


4.
 SRS-ECU



Installation steps

>>A<<
 4.
 SRS-ECU


3.
 SRS-ECU mounting bolt


2.
 SRS-ECU mounting bolt

>>B<<
 1.
 SRS-ECU mounting bolt (earth bolt)


·
 Floor console bracket front (Refer to GROUP 52A - Front Floor Console Assembly ).

>>C<<
 ·
 Post-installation inspection

INSTALLATION SERVICE POINTS

>>A<< SRS-ECU INSTALLATION
caution If SRS-ECU is not securely and correctly installed, the correct operation of SRS air bag is prevented.

>>B<< SRS-ECU MOUNTING BOLT (EARTH BOLT) INSTALLATION

Check the head mark "E" and install the earth bolt.

>>C<< POST-INSTALLATION INSPECTION
1.Connect the negative (-) battery cable.
2.Turn the ignition switch to the "ON" position.

3.Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
4.If the lamp does not extinguish, perform the troubleshooting (Refer to ).