Code No. C1747: Shift signal undetermined
caution |
If a diagnosis code is set, be sure to diagnose the CAN bus line.
|
DIAGNOSTIC FUNCTION
If the laser radar receives a signal indicating that the position of the selector lever is not determined from the CVT-ECU, diagnosis code No. C1747 is set.
note |
Also, when the selector lever is held in the neutral position, the diagnosis code may be set.
|
CHECK CONDITION
When all the following conditions are satisfied
- After the ignition switch is turned ON, two or more seconds passed.
- After the engine has started
- The vehicle speed is 5 km/h or more.
PROBABLE CAUSES
- Malfunction of the CVT system (inhibitor switch)
- Malfunction of the CAN bus line
- Malfunction of the laser radar
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnosis
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting
).
STEP 2. CVT-ECU service data check
Check the service data related to the inhibitor switch of the CVT-ECU (Refer to GROUP 23A - Troubleshooting
).
- Item No.61: Inhibitor switch
Q.
Is the check result normal?
Go to Step 3.
Perform diagnosis code No. P0705 of the CVT-ECU (Refer to GROUP 23A - Troubleshooting
).
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the laser radar.
|
(1)Erase the set diagnosis code.
|
|
(2)Turn the ignition switch to the "LOCK" (OFF) position.
|
|
(3)Drive at 5 km/h or more.
|
|
(4)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the laser radar (Refer to
).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction
).