INSPECTION
PROCEDURE 2: Cool air does not come
|
If the blower air temperature can not be cool when turning A/C switch ON and
lowering the preset temperature, inadequate refrigerant quantity, sensors, harness or connectors
may be suspected.
|
|
Damaged wiring harness or connectors
|
|
STEP 1. Check the blower operation
|
|
Check that air blows through the air outlets.
|
|
(1)Turn the ignition switch to the "ON" position.
|
|
(2)Blower knob: Other than "OFF"
|
|
(3)Check that the air comes out of the blower.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Refer to Inspection Procedure 3 "The blower does not work ."
|
|
|
|
STEP 2. Check the A/C compressor operation
|
|
Check that the compressor operates under the following conditions.
|
|
- Engine operation
- Air conditioner switch: "ON"
- Blower knob: Maximum air volume
- Temperature control dial: "MAX COOL"
|
|
note |
The compressor does not work when the blower intake temperature is 0°C or less.
|
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Refer to INSPECTION PROCEDURE 7: "The A/C compressor does not work ."
|
|
|
|
STEP 3. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 4.
|
|
|
|
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting ).
|
|
|
|
STEP 4. M.U.T.-III diagnosis code
|
|
Check that the diagnosis code related to the air conditioner is not set.
|
|
Q.
Is the diagnosis code set?
|
|
Carry out the diagnosis code procedures. Refer to .
|
|
|
|
Go to Step 5.
|
|
|
|
STEP 5. Check the refrigerant level.
|
|
Refer to .
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).
|
|
|
|
Correct the refrigerant amount.
|
|
|