REMOVAL AND INSTALLATION

<M/T>

			Crankshaft front oil seal removal steps
		·	Valve timing belt, balancer timing belt (Refer to ).
	>>D<<	1.	Crankshaft balancer shaft drive sprocket
		2.	Crankshaft key
	>>C<<	3.	Crankshaft front oil seal
			Crankshaft rear oil seal removal steps
<<A>>		·	Transmission assembly
		·	Clutch cover and clutch disc (Refer to GROUP 21B, Clutch ).
<<B>>	>>B<<	4.	Flywheel bolts
		5.	Flywheel adapter plate
		6.	Flywheel assembly
		7.	Flywheel adapter plate
		8.	Crankshaft bush
	>>A<<	9.	Crankshaft rear oil seal

<A/T>

			Crankshaft front oil seal removal steps
		·	Valve timing belt, balancer timing belt (Refer to ).
	>>D<<	1.	Crankshaft balancer shaft drive sprocket
		2.	Crankshaft key
	>>C<<	3.	Crankshaft front oil seal
			Crankshaft rear oil seal removal steps
		·	Transmission assembly (Refer to GROUP 23A, Transmission Assembly ).
<<B>>	>>B<<	4.	A/T drive plate bolts
		5.	A/T drive plate adapter plate
		6.	A/T drive plate
		7.	Crankshaft bush
	>>A<<	8.	Crankshaft rear oil seal

REMOVAL SERVICE POINTS

<<A>> TRANSMISSION ASSEMBLY REMOVAL

caution

Do not remove the flywheel bolt. If this bolt is removed, the flywheel assembly will become out of balance and damaged.

Refer to GROUP 22A, Transmission Assembly

<<B>> FLYWHEEL BOLTS/A/T DRIVE PLATE BOLTS REMOVAL

1.Use special tool flywheel stopper (MD998781) to secure the flywheel assembly or A/T drive plate.
2.Remove the flywheel bolts or A/T drive plate bolts.

INSTALLATION SERVICE POINTS

>>A<< CRANKSHAFT REAR OIL SEAL INSTALLATION

1.Apply a small amount of engine oil to the entire inner diameter of the oil seal lip.
2.Use the following special tools to press-fit the oil seal.

Installer bar (MB990938)
Crankshaft rear oil seal installer (MD998776)

>>B<< FLYWHEEL BOLTS/A/T DRIVE PLATE BOLTS INSTALLATION

1.Use special tool flywheel stopper (MD998781) to secure the flywheel assembly or A/T drive plate in the same manner as removal.
2.Tighten the flywheel bolts or A/T drive plate bolts to the specified torque.
Tightening torque: 132 ± 5 N·m

>>C<< CRANKSHAFT FRONT OIL SEAL INSTALLATION

1.Apply a small amount of engine oil to the outer diameter of special tool crankshaft front oil seal guide (MD998285) and install it to the crankshaft.
2.Apply a small amount of engine oil to the entire inner diameter of the oil seal lip.
3.Use special tool crankshaft front oil seal installer (MD998375) to press-fit the oil seal.

>>D<< CRANKSHAFT BALANCER SHAFT DRIVE SPROCKET INSTALLATION

1.Clean or degrease the front case, the crankshaft and the crankshaft balancer shaft drive sprocket as shown.

note

Also clean the degreased surfaces.

2.Install the crankshaft balancer shaft drive sprocket in the direction shown in the illustration.