REMOVAL AND INSTALLATION



Removal steps


1.
 Oil level gauge


2.
 Oil level gauge guide


3.
 O-ring


4.
 Auto tensioner


5.
 Crankshaft pulley


6.
 Water pump pulley


7.
 Idler pulley


8.
 Connector bracket


9.
 Alternator


10.
 Ignition coil
<<A>>
 >>C<<
 11.
 Spark plug


12.
 Connector bracket


13.
 Camshaft position sensor


14.
 O-ring

>>B<<
 15.
 Camshaft position sensor support
<<B>>
 >>A<<
 16.
 Camshaft position sensing cylinder

REMOVAL SERVICE POINT

<<A>> SPARK PLUG REMOVAL

Using special tool Spark plug wrench (MB991398), removal the spark plug.

<<B>> CAMSHAFT POSITION SENSING CYLINDER REMOVAL


1.Using special tool Flywheel stopper (MD998781), hold the drive plate.
2.Removal the camshaft position sensing cylinder.

INSTALLATION SERVICE POINT

>>A<< CAMSHAFT POSITION SENSING CYLINDER INSTALLATION


1.Using special tool Flywheel stopper (MD998781), hold the drive plate.
2.Tighten the camshaft position sensing cylinder to the specified torque.
Tightening torque: 22 ± 4 N·m

>>B<< CAMSHAFT POSITION SENSOR SUPPORT INSTALLATION

1.Remove completely the FIPG remaining on the camshaft position sensor support and cylinder head.
2.Apply a 3 ± 1 mm diameter bead of FIPG to the indicated surface of the camshaft position sensor support.
Specified sealant:
    Mitsubishi Genuine Part No.MD970389 or equivalent

>>C<< SPARK PLUG INSTALLATION

Using special tool Spark plug wrench (MB991398), tighten the spark plug to the specified torque.
Tightening torque: 25 ± 5 N·m