REMOVAL AND INSTALLATION

			Removal steps
		1.	Engine hanger
<<A>>	>>B<<	2.	Oxygen sensor
<<A>>	>>B<<	3.	Oxygen sensor
		4.	Exhaust manifold cover
	>>A<<	5.	Exhaust manifold bracket B
		6.	Exhaust manifold
		7.	Exhaust manifold gasket
		8.	Exhaust manifold bracket A

REMOVAL SERVICE POINT

<<A>> OXYGEN SENSOR REMOVE

Using special tool Oxygen sensor wrench (MD998770), removal the oxygen sensor.

INSTALLATION SERVICE POINT

>>A<< EXHAUST MANIFOLD BRACKET "B" INSTALLATION

Check to ensure that the exhaust manifold bracket "B" is in close contact with the exhaust manifold and the cylinder block before tightening the respective mounting bolts to the specified torque.

>>B<< EXHAUST MANIFOLD COVER / OXYGEN SENSOR INSTALLATION

1.Install the exhaust manifold cover to the exhaust manifold.

2.Temporarily tighten the exhaust manifold cover bolt.

3.Using special tool Oxygen sensor wrench (MD998770), install both of the oxygen sensors to the exhaust manifold.

note

Do not remove the special tool after the oxygen sensor is installed.

4.Tighten the exhaust manifold cover bolt to the specified torque of 14 ± 1N·m.
5.Remove the special tool.