REMOVAL AND INSTALLATION


<L.H. DRIVE VEHICLES>


caution Always register the ignition key(s) when the engine-ECU <M/T> or the engine-A/T-ECU <A/T> is replaced (Refer to GROUP 54A, On-vehicle Service - Immobilizer ID Code Registration ) <Vehicles for GCC> .
Pre-removal Operation
  • Front Scuff Plate (RH), Cowl Side Trim (RH) Removal (Refer to GROUP 52A Trims ).
  • Console Side Cover (RH) Removal (Refer to GROUP 52A, Floor Console assembly ).

 Post-installation Operation
  • Console Side Cover (RH) Installation (Refer to GROUP 52A, Floor Console assembly ).
  • Front Scuff Plate (RH), Cowl Side Trim (RH) Installation (Refer to GROUP 52A Trims ).




Removal steps

>>A<<
 ·
 Initialization (Installation only)


·
 Turn up the floor mat. <Front passenger’s side>


1.
 Wiring harness clamp connection


2.
 Bracket


3.
 Engine-ECU connector <M/T> or Engine-A/T-ECU connector <A/T>


4.
 Engine-ECU <M/T> or Engine-A/T-ECU <A/T>

INSTALLATION SERVICE POINT

>>A<< INITIALIZATION
When the Engine-ECU <M/T> or Engine-A/T-ECU <A/T> is replaced, initialize the electronic-controlled throttle valve system according to the procedure below beforehand.
1.Turn the ignition switch to the ON position, and back to the "LOCK" (OFF) position. Then hold it in this position for approximately 10 seconds or more.

<R.H. DRIVE VEHICLES>


caution Always register the ignition key(s) when the the engine-A/T-ECU is replaced (Refer to GROUP 54A, On-vehicle Service - Immobilizer ID Code Registration ) <Vehicles for Australia and New Zealand> .
Pre-removal Operation
  • Front Scuff Plate (LH), Cowl Side Trim (LH) Removal (Refer to GROUP 52A Trims ).
  • Console Side Cover (LH) Removal (Refer to GROUP 52A, Floor Console assembly ).

 Post-installation Operation
  • Console Side Cover (LH) Installation (Refer to GROUP 52A, Floor Console assembly ).
  • Front Scuff Plate (LH), Cowl Side Trim (LH) Installation (Refer to GROUP 52A Trims ).




Removal steps

>>A<<
 ·
 Initialization (Installation only)


·
 Turn up the floor mat. <Front passenger’s side>


1.
 Wiring harness clamp connection


2.
 Wiring harness clamp connection


3.
 Bracket


4.
 Engine-A/T-ECU connector


5.
 Engine-A/T-ECU

INSTALLATION SERVICE POINT

>>A<< LNITIALIZATION
When the Engine-A/T-ECU is replaced, initialize the electronic-controlled throttle valve system according to the procedure below beforehand.
1.Turn the ignition switch to the ON position, and back to the "LOCK" (OFF) position. Then hold it in this position for approximately 10 seconds or more.