REMOVAL AND INSTALLATION


caution Always register the ignition key(s) when the engine-A/T-ECU is replaced (Refer to GROUP 54A, On-vehicle Service - Immobilizer ID Code Registration ).
Pre-removal Operation
  • Front Scuff Plate (LH), Cowl Side Trim (LH) Removal (Refer to GROUP 52A Trims ).
  • Console Side Cover (LH) Removal (Refer to GROUP 52A, Floor Console assembly ).

 Post-installation Operation
  • Console Side Cover (LH) Installation (Refer to GROUP 52A, Floor Console assembly ).
  • Front Scuff Plate (LH), Cowl Side Trim (LH) Installation (Refer to GROUP 52A Trims ).




Removal steps

>>A<<
 ·
 Initialization (Installation only)


·
 Turn up the floor mat. <Front passenger’s side>


1.
 Wiring harness clamp connection


2.
 Wiring harness clamp connection


3.
 Bracket


4.
 Engine-A/T-ECU connector


5.
 Engine-A/T-ECU

INSTALLATION SERVICE POINT

>>A<< INITIALIZATION
When the Engine-A/T-ECU is replaced, initialize the electronic-controlled throttle valve system according to the procedure below beforehand.
1.Turn the ignition switch to the ON position, and back to the "LOCK" (OFF) position. Then hold it in this position for approximately 10 seconds or more.