FAN CONTROLLER CHECK

1.Remove the fan controller connector. 2.Turn the ignition switch to the "ON" position, and measure the voltage between the harness-side connector terminals. Standard value: System voltage

3.Connect the fan controller connector, and disconnect the condenser fan motor connector. 4.Ensure that the A/C switch is off, and start the engine and run it at idle. 5.Measure the voltage between the fan controller-side connector terminals. Standard value: 1V or less 6. warning Stay clear of the fan when the fan starts running. Turn the A/C switch to the "ON" position. 7.Measure the voltage between the fan controller-side connector terminals while the fan is running. The voltage should repeat the values below. Standard value: 8.2 ± 2.6 V System voltage ± 2.6 V 8.If the voltage does not repeatedly change as indicated, replace the cooling fan motor and fan controller.