![](../../../img/16/AK304670AA00ENG.png)
|
caution |
Do not insert the screwdriver
blades too deep. Doing so could damage the
stator coil.
|
Insert the blades of screwdrivers between the front
bracket assembly and stator core, and pry and separate them
with the screwdrivers.
|
![](../../../img/16/AK304671AA00ENG.png)
|
caution |
Perform operation carefully
not to damage the rotor.
|
Clamp the rotor in a vise with the pulley facing up
to remove the pulley.
|
![](../../../img/16/AK304672AB00ENG.png)
|
caution |
- Use a 180 -
250 W soldering iron, and finish
unsoldering within four seconds. Diodes
will be damaged by heat if unsoldering
time is too long.
- Avoid applying undue force to the diode
leads.
|
1.Unsolder the stator leads from the main
diode of the rectifier assembly when the stator is
removed. 2.When removing the rectifier assembly
from the regulator assembly, undo the soldered points on the
rectifier assembly.
|
![](../../../img/16/AK304673AB00ENG.png)
![](../../../img/16/AK304674AB00ENG.png)
|
After installing the regulator
assembly, insert a piece of wire through the hole in the
rear bracket while pressing the brush to keep the brush
against movement.
note |
Holding the brush with the
wire facilities installation of the
rotor.
|
|
![](../../../img/16/AK304673AB00ENG.png)
|
Remove the brush holding wire after
the rotor has been installed.
|