DISASSEMBLY AND REASSEMBLY



Disassembly steps


1.
 Spring washer


2.
 Stopper bracket
<<A>>
 >>E<<
 3
 Lock pin


4.
 Interlock plate


5.
 Control finger

>>D<<
 6.
 Spring pin


7.
 Stopper body


8.
 Spring


9.
 Control shaft

>>C<<
 10.
 Air breather


11.
 Control shaft boot

>>B<<
 12.
 Oil seal

>>A<<
 13.
 Needle bearing


14.
 Control housing

DISASSEMBLY SERVICE POINT

<<A>> LOCK PIN REMOVAL

Drive out the lock pin from the direction shown.

REASSEMBLY SERVICE POINTS

>>A<< NEEDLE BEARING INSTALLATION

Press fit the needle bearing into the control housing side as shown.
Make sure that the side with the model number stamped on it faces the end of the control housing as shown.

>>B<< OIL SEAL INSTALLATION

Apply gear oil (Hypoid gear oil SAE 75W-90 or 75W-85W conforming to API classification GL-4) to the oil seal lip area.

>>C<< AIR BREATHER INSTALLATION

1.Apply sealant to the inserting portion of air breather.
Specified sealant:
    3M SUPER WEATHERSTRIP No.8001 or equivalent

2.Install the air breather so that the emboss mark is in the direction shown in the figure.

>>D<< SPRING PIN INSTALLATION

Drive in the spring pin so that the slit is in the direction shown in the figure.

>>E<< LOCK PIN INSTALLATION

Drive the lock pin in from the direction shown in the figure.