DISASSEMBLY AND REASSEMBLY



Disassembly steps

>>C<<
 1.
 Oil seal

>>B<<
 2.
 Needle bearing


3.
 Oil guide


4.
 Snap ring

>>A<<
 5.
 Bushing


6.
 Transmission case
note * Refer to the needle bearing and bushing installation procedures only when replacing the transmission case.

REASSEMBLY SERVICE POINTS

>>A<< BUSHING INSTALLATION

1.Press fit the bushing so the seam is away from the air vent.

2.Be sure the bushing is fully seated as shown. It must be 3 mm below the housing surface.

>>B<< NEEDLE BEARING INSTALLATION
1.Check the installation direction of the needle bearing.

2.Press fit the needle bearing until it is flush with the case.

>>C<<OIL SEAL INSTALLATION

1.Apply gear oil (Hypoid gear oil SAE 75W-90 or 75W-85W conforming to API classification GL-4).

2.Using special tool Differential oil seal installer (MD998325), press fit the oil seal into the transaxle case.