REMOVAL AND INSTALLATION


caution When removing and installing the transmission control cable, shift lock and key interlock cable, be careful not to hit the SRS-ECU.
Pre-removal Operation
  • Centre Console Removal (Refer to GROUP 52A, Instrument Panel Assembly ).

 Post-installation Operation
  • Centre Console Installation (Refer to GROUP 52A, Instrument Panel Assembly ).
  • Key Interlock and Shift Lock Mechanism Check (Refer to ).
  • Selector Lever Operation Check (Refer to ).




Selector lever assembly and transmission control cable assembly removal steps


·
 Shift the selector lever to the N position.
<<A>>
1.
 Selector lever knob


·
 Selector lever panel (Refer to GROUP 52A - Instrument panel assembly ).


2.
 Shift switch assembly connector connection


·
 SRS-ECU (Refer to GROUP 52B - SRS Air Bag Control Unit <Except for Hong Kong and Singapore> or <Vehicles for Hong Kong and Singapore>).


3.
 Selector lever assembly coupling bolts connection

>>B<<
 4.
 Key interlock cable connection (selector lever assembly side) <Vehicles for Hong Kong and Singapore>


5.
 Shift lock cable connection (selector lever assembly side) <Vehicles for Hong Kong and Singapore>


6.
 Transmission control cable assembly connection (selector lever assembly side)


7.
 Selector lever assembly


·
 Battery and battery tray


·
 Air cleaner body assembly (Refer to GROUP 15 - Air cleaner ).


8.
 Transmission control cable assembly connection (transmission side)

>>A<<
 9.
 Transmission control cable assembly side

REMOVAL SERVICE POINTS

<<A>> SELECTOR LEVER KNOB REMOVAL

Pull out the selector knob to the direction shown.

INSTALLATION SERVICE POINTS

>>A<< TRANSMISSION CONTROL CABLE (TRANSMISSION SIDE) INSTALLATION
1.Place the selector lever and manual control lever in the N position.

2.Tighten the transmission control cable locking nut to the specified torque.
Tightening torque: 12 ± 2 N·m

>>B<< KEY INTERLOCK CABLE INSTALLATION
1.Selector lever to P position.
2.Turn the ignition key to LOCK (OFF) position.

3.Install the tip of the key interlock cable to the lock cam of the selector lever assembly taking care not to twist the inner cable.
4.Lift the lock guide (unlocked position) and then install the adjuster case.
5.Lower the lock guide thoroughly and lock it.
note The lock position of the key interlock cable is automatically adjusted by a spring.