|
1.Remove the caliper
assembly, and suspend the caliper assembly with a wire and
remove the brake disc.
|
|
2.Turn the hub a few times
to seat the bearing.
|
![](../../../img/27/AC302113AA00ENG.png)
|
3.Wind a rope around the hub
bolt and turn the hub by pulling at a 90° angle with a
spring balance. Measure to determine whether or not the
rotary-sliding resistance of the wheel bearing is at the
limit value. Limit: 19 N 4.If
limit value is exceeded, replace the rear hub
assembly. 5.After having checked, install the
brake disc, the caliper assembly and tighten the caliper
mounting bolt to the specified
torque. Tightening torque: 60 ± 5
N·m
|