REMOVAL AND INSTALLATION


caution
  • Do not disassemble the rear wheel hub assembly.
  • The magnetic encoder collects any metallic particle easily, because it is magnetized. Make sure that the magnetic encoder should not collect any metallic particle. Check that there is not any trouble inside of bearing prior to reassembling it.
  • When the rear wheel hub assembly is removed and installed, make sure that the magnetic encoder does not contact with surrounding parts to avoid damage.




Removal steps


1.
 Rear wheel speed sensor
<<A>>
2.
 Caliper assembly
<<B>>
3.
 Brake disc


4.
 Rear wheel hub assembly

REMOVAL SERVICE POINTS

<<A>> CALIPER ASSEMBLY REMOVAL
Secure the removed caliper assembly with wire, etc.

<<B>> BRAKE DISC REMOVAL

If the brake disc is seized, install M8 × 1.25 bolts as shown, and remove the disc by tightening the bolts evenly and gradually.