REMOVAL AND INSTALLATION


caution *: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the ground in the unladen condition.
Pre-removal Operation
  • Rear Brake Caliper Assembly and Brake Disc Removal (Refer to GROUP 35A, Rear Disc Brake Assembly ).
  • Rear Hub Assembly Removal (Refer to GROUP 27, Rear Axle Hub Assembly ).
  • Parking Brake Shoe and Lining Assembly Removal (Refer to GROUP 36, Parking Brake Lining and Drum ).
  • Parking Brake Rear Cable Clamp and Backing Plate side disconnection (Refer to GROUP 36, Parking Brake Cable , .)
  • Rear Wheel Speed Sensor Removal (Refer to GROUP 35B, Wheel Speed Sensor ).
  • Backing Plate Removal (Refer to GROUP 36, Parking Brake Lining and Drum ).
  • Rear Suspension Coil Spring Removal (Refer to ).
  • Rear Brake Hose Clamp disconnection

 Post-installation Operation
  • Rear Brake Hose Clamp connection
  • Rear Suspension Coil Spring Installation (Refer to ).
  • Backing Plate Installation (Refer to GROUP 36, Parking Brake Lining and Drum ).
  • Rear Wheel Speed Sensor Installation (Refer to GROUP 35B, Wheel Speed Sensor ).
  • Parking Brake Rear Cable Clamp and Backing Plate side connection (Refer to GROUP 36, Parking Brake Cable , .)
  • Parking Brake Shoe and Lining Assembly Removal (Refer to GROUP 36, Parking Brake Lining and Drum ).
  • Rear Hub Assembly Installation (Refer to GROUP 27, Rear Axle Hub Assembly ).
  • Rear Brake Caliper Assembly and Brake Disc Installation (Refer to GROUP 35A, Rear Disc Brake Assembly ).
  • Rear Wheel Alignment Check and Adjustment (Refer to ).
  • Parking Brake Lever Stroke Adjustment (Refer to GROUP 36, On-vehicle Service - Parking Brake Lever Stroke Check and Adjustment ).





Removal steps
<<A>>
 >>B<<
 1.
 Rear suspension independent arm bolt


2.
 Rear suspension lower arm plate


3.
 Rear suspension independent arm bolt

>>A<<
 4.
 Rear suspension trailing arm bushing stopper


5.
 Semi-trailing arm assembly (lower armassembly)

REMOVAL SERVICE POINT

<<A>> REAR SUSPENSION INDEPENDENT ARM BOLT REMOVAL

After making the alignment marks on bolt and rear suspension crossmember, remove the bolt.

INSTALLATION SERVICE POINTS

>>A<< REAR SUSPENSION TRAILING ARM BUSHING STOPPER INSTALLATION

1.After aligning the stopper notch and semi-trailing arm (lower arm) boss, insert the stopper into the semi-trailing arm (lower arm).
2.Rotate the stopper by 90 degrees and fix it.

>>B<< REAR SUSPENSION INDEPENDENT ARM BOLT INSTALLATION
Align the mating marks and install the bolt.