![](../../../img/35/AC310120AB00ENG.png)
|
caution |
Before connecting or
disconnecting the M.U.T.-III, turn the ignition
switch to the "LOCK"
(OFF) position.
|
(1)Connect M.U.T.-III to the 16-pin diagnosis
connector. (2)Turn the ignition switch to the "ON"
position. (3)Diagnose the CAN bus line. (4)Turn the
ignition switch to the "LOCK" (OFF) position.
Q.
Is the check result normal?
Go to Step
2.
Repair the
CAN bus line (Refer to GROUP 54F, CAN bus line Diagnostic
flow ).
Then go to Step 2.
|
![](../../../img/35/AC310120AB00ENG.png)
|
caution |
Before connecting or
disconnecting the M.U.T.-III, turn the ignition
switch to the "LOCK"
(OFF) position.
|
(1)Turn the ignition switch to the "ON"
position. (2)Erase the diagnosis code. (3)Turn the
ignition switch to the "LOCK" (OFF) position. (4)Turn the
ignition switch to the "ON" position. (5)Check if the
diagnosis code is set. (6)Turn the ignition switch to the
"LOCK" (OFF) position.
Q.
Is code No.C1607 set?
Replace the
hydraulic unit (integrated with ABS-ECU).
The procedure is
complete.
|