|
1.
| caution |
- Do not remove the tie rod end nut from
the ball joint. Loosen
it and use special tool to avoid
possible damage to the ball joint
threads.
- Hang special tool with cord to prevent
it from falling.
|
Install special tool ball joint remover (MB991897)
as shown in the figure.
|
|
2.Turn the bolt and knob as
necessary to make the jaws of special tool parallel, tighten
the bolt by hand and confirm that the jaws are still
parallel.
| note |
When adjusting the jaws in
parallel, make sure the knob is in the position
shown in the figure.
|
3.Tighten the bolt with a wrench to
disconnect the tie rod end.
|
|
4.Move the ball joint stud
several times and install the nut on the stud. Using special
tool preload socket (MB990326), measure the ball joint
turning torque.
Standard value: 3.9 N·m
or less
5.If the turning torque exceeds
the standard value, replace the tie rod end. (Refer
to  )
6.If
the turning torque is under the standard value, check the
ball joint for axial
play or ratcheting. If no axial play or ratcheting, the ball
joint can be re-used. (Refer to )
7.
| caution |
Always use a new ball joint
nut as it is a self-locking
nut.
|
Install the tie rod end to the knuckle, then tighten
a new self-locking nut to the specified
torque.
Tightening torque: 25 ± 5
N·m
|