REMOVAL AND INSTALLATION
Pre-removal Operation
Power Steering Fluid Draining (Refer to
.)
Under cover (RH) removal
Post-installation Operation
Under cover (RH) installation
Power steering fluid refilling and air bleeding (Refer to
).
Drive belt tension adjustment (Refer to GROUP 11A, Engine adjustment
.)
Removal steps
1.
Drive belt (Refer to GROUP 11A, Timing belt
.)
>>A<<
2.
Suction hose connection
3.
Brake fluid level switch connector and clamp
4.
Heat protector <RH drive vehicles>
5.
Hose clip <RH drive vehicles>
6.
Brake fluid reservoir assembly <RH drive vehicles>
7.
Eye bolt
8.
Gasket
9.
Pressure hose connection
10.
Power steering oil pressure sensor harness clamp (Oil pump side)
11.
Control harness clamp (2 clamps at engine side)
12.
Battery harness clamp (two clamps at engine side, a clamp at level gauge side)
13.
Level gauge
14.
O-ring
15.
Oil pump bracket and oil pump assembly
16.
Oil pump bracket
17.
Oil pump assembly
INSTALLATION SERVICE POINT
>>A<< SUCTION HOSE INSTALLATION
Align the suction hose marking (yellow) as shown and connect the suction hose.