![](../../../img/37/AC000996AC00ENG.png)
|
Using special tool preload socket
(MB991006), rotate the pinion gear at the rate of one
rotation in approximately 4 to 6 seconds to check the total
pinion torque. Standard value: 0.8 -
2.1 N·m [Change in torque: 0.6 N·m
or less]
note |
When measuring, remove the
bellows from the rack housing. Measure the
pinion torque through
the whole stroke of the rack. If the measured
value is not within the standard range, first
adjust the rack support
cover, and then check the total pinion torque
again. If the total pinion torque cannot be
adjusted to within the standard range by
adjusting
the rack support cover, check the rack support
cover, rack support spring, rack support and
replace
any parts if necessary.
|
|
|
1.Give 10 hard swings to the
tie rod.
|
![](../../../img/37/AC000997AA00ENG.png)
|
2.Measure the tie rod swing
resistance [tie rod swing torque]
with
a spring balance. Standard value: 6 -
19 N [1.5 -
4.9 N·m] 3.If the measured
value exceeds the standard value, replace the tie
rod. 4.If the measured value is below the standard
value, the tie rod can be re-used if it
swings smoothly without excessive play.
|
|
1.Check the dust cover for
cracks or damage by pushing it with your finger.
|
|
2.If the dust cover is
cracked or damaged, replace the tie rod end (Refer to ).
note |
Cracks or damage of the dust
cover may damage the ball joint. If it is
damaged during service
work, replace the dust cover (Refer to ).
|
|