![](../../../img/42/AC311244AB00ENG.png)
|
1.Remove the power window
fuse and connect an ammeter as shown in the
illustration. 2.When the power window switch is
pressed to the “UP”
position, a large amount of current flows at the time the
window starts to close and when it is fully closed, so
measure the operation current in the interval between these
two points. Standard value: 7A or less (Power
supply voltage 14.5 ±
0.5V, 25°C)
note |
If the power supply voltage
does not meet the standard value, check and
repair the alternator and the battery. Then
carry out this check again.
|
3.If the operation current is outside the
standard value, refer to .
|