DISASSEMBLY AND REASSEMBLY

		Removal steps
		1.	Front three-diamond mark
		2.	Front bumper upper grille
		3.	Front grille upper reinforcement
		4.	Front bumper lower grille <Vehicles for GCC>
		5.	Bumper centre net <Except vehicles for GCC>
		6.	Air intake bezel <Vehicles for GCC>
<<A>>	>>A<<	7.	Rivets
		8.	Front bumper side plate
		9.	Towing cover
		10.	Front fog lamp assembly <Except vehicles for GCC>
		11.	Corner senser harness <Vehicles for Hong Kong and Singapore>
		12.	Corner senser <Vehicles for Hong Kong and Singapore>
		13.	Front bumper face

DISASSEMBLY SERVICE POINT

<<A>> RIVETS REMOVAL

Use a drill (4.0 mm) to make a hole in the rivet to break it, and then remove the rivet.

REASSEMBLY SERVICE POINT

>>A<< RIVETS ASSEMBLY

Use recommended tool shown in the illustration to connect the rivet by the following procedure.
1.Insert the rivet into the base material (front bumper face and front bumper side plate assembly).
2.Place the recommended tool over section A of the rivet.
3.While pushing the flange surface of the rivet with the recommended tool, press the handle of the tool.
4.The thin part of section A of the rivet will break and the rivet will then be attached.