REMOVAL AND INSTALLATION
<<A>>
1.
 Mirror



Door mirror outer cover removal steps
<<A>>
1.
 Mirror
<<B>>
 >>A<<
 2.
 Door mirror outer cover


3.
 Side turn-signal lamp



Door mirror assembly removal steps


·
 Front door trim (Refer to group 52A, Door trim .)


4.
 Door mirror assembly


5.
 Clip



Remote controlled mirror switch removal steps


·
 Instrument panel under cover (Refer to group 52A, Instrument panel assembly .)


6.
 Remote controlled mirror switch

REMOVAL SERVICE POINT

<<A>> MIRROR REMOVAL
caution The tab of the mirror is prone to breakage when working in cold temperatures. Always use a hair drier or the like to warm up the mirror tab and its periphery to 20°C or higher prior to works. When the mirror is heated too quickly from its cold state, it may be broken.

1.Slant the mirror upward with your hands. Then insert a flat-tipped screwdriver wrapped with protective tape between the pivot plate and mirror through the cut-out from behind the mirror. Now pry off the mirror tab and release the lower side of the mirror as shown in the illustration.

2.Release the upper side of the mirror from the tab as shown while pulling out the mirror.
3.Disconnect the connector of the heated mirror.

<<B>> DOOR MIRROR OUTER COVER REMOVAL

Remove the door mirror outer cover by disengaging the tabs in the numerical order of the illustration from the mirror body side.

INSTALLATION SERVICE POINT

>>A<< DOOR MIRROR OUTER COVER INSTALLATION
caution Tap the six tab positions securely to confirm that they are engaged securely.

There should be a space between the door mirror outer cover and the rain gutter as shown.