DISASSEMBLY AND REASSEMBLY

			Disassembly steps
<<A>>	>>B<<	1.	Connector
		2.	Body base assembly
		3.	Base
		4.	Body cover
	>>A<<	5.	Actuator
		6.	Support assembly
		7.	Harness assembly
		8.	Body
		9.	Support
		10.	Retractor motor

DISASSEMBLY SERVICE POINT

<<A>> CONNECTOR REMOVAL

Use a flat-tipped screwdriver to pull up the retainer shown slightly (by a few millimeter). Then disengage the wiring harness terminals to disconnect the connector.

REASSEMBLY SERVICE POINT

>>A<< ACTUATOR INSTALLATION

1.Check that the wiring harness wires are secured with the connector as shown.

note

Check that the wires are secured as these wires may be released from the connector easily.

2.Confirm the wiring harness assembly connectors of the same colour as the the colour engraved on the actuator. Connect the connectors to the actuator as shown according to the colours, respectively.
3.Install the actuator to the support assembly.

>>B<< CONNECTOR INSTALLATION

Pull out the connector retainer slightly until it is loosely fitted. Insert the wiring harness wires of the shown colours to the connector, respectively. Then push in the retainer until it clicks in to position.