REMOVAL AND INSTALLATION


warning
  • Never repair or disassemble the front impact sensor. If faulty, replace it.
  • Do not drop or subject the front impact sensor to impact or vibration. If denting, cracking, deformation, or rust are discovered in the front impact sensor, replace it with a new front impact sensor. Discard the old one.
  • After deployment of an air bag, replace the front impact sensor with a new one.
Pre-removal Operation
  • Turn the ignition key to the "LOCK" (OFF) position.





Removal step
<<A>>
1.
 Negative battery cable connection


·
 Battery


2.
 Front impact sensor



Installation steps

>>A<<
 ·
 Pre-installation inspection

>>B<<
 2.
 Front impact sensor


·
 Battery


1.
 Negative battery cable connection

>>C<<
 ·
 Post-installation inspection
note The figure indicates the left front impact sensor. The right impact sensor is symmetrical to this.

REMOVAL SERVICE POINT

<<A>>NEGATIVE BATTERY CABLE DISCONNECTION
danger Wait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to ).
warning Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.

INSTALLATION SERVICE POINTS

>>A<<PRE-INSTALLATION INSPECTION
When installing the new front impact sensor, refer to "INSPECTION."

>>B<<FRONT IMPACT SENSOR INSTALLATION
warning The SRS may not activate properly if a front impact sensor is not installed properly, which could result in serious injury or death to the vehicle’s driver.
1.Securely connect the connector.
2.Position the front impact sensor facing toward the front of the vehicle as indicated by the arrow on the label, and install it securely.

>>C<<POST-INSTALLATION INSPECTION
1.Reconnect the negative battery cable.
2.Turn the ignition key to "ON" position.

3.Does the SRS warning lamp illuminate for about 7 seconds, and go out?
4.If yes, the SRS system is functioning properly.
If not, consult page .