![](../../../img/54/AC313574AC00ENG.png)
|
1.Measure the centre of the
front fog lamps, as shown in the
illustration. 2.Set the distance between the
screen and the centre of the front fog lamps as shown
in the illustration. 3.Inflate the types to the
specified pressures and there should be no other load in
the vehicles other than driver or substituted weight of
approximately 75 kg placed in the driver’s
position. 4.With the engine running at 2,000
r/min, aim the front fog lamp.
|
![](../../../img/54/AC312871AB00ENG.png)
|
5.Check if the beam shining
onto the screen is at the standard
value. Standard value: (Vertical direction)
100 mm below horizontal (H) (Horizontal direction)
Parallel to direction of vehicle travel
|
![](../../../img/54/AC312873AC00ENG.png)
![](../../../img/54/AC313575AB00ENG.png)
|
caution |
When marking the aiming
adjustment, be sure to mask those lamps which
are not being adjusted.
|
note |
The horizontal direction is
non-adjustable. If the deviation of the light
beam axis exceeds
the standard value, check to be sure that the
mounting location or some other point is not
defective.
|
|