![](../../../img/54/AC302572AD00ENG.png)
![](../../../img/54/AC313355AK00ENG.png)
![](../../../img/54/AC313367AJ00ENG.png)
![](../../../img/54/AC313371AN00ENG.png)
|
caution |
The strand end of the twist
wire should be within 10 cm from
the connector. For details refer to .
|
|
![](../../../img/54/AC209350AB00ENG.png)
|
When checking the joint connector,
ensure that its wiring harness side and its short pins
are not damaged.
Q.
Is the check result normal?
Go to Step
2.
Repair a
defective connector or replace the joint connector (front
wiring harness
assembly).
|
![](../../../img/54/AC302572AD00ENG.png)
![](../../../img/54/AC313355AK00ENG.png)
![](../../../img/54/AC313367AJ00ENG.png)
![](../../../img/54/AC313371AN00ENG.png)
|
(1)Disconnect the joint connector
(CAN1) and the ABS-ECU connector, and measure at the wiring
harness side. (2)Ignition switch: OFF (LOCK) (3)
caution |
When measuring the resistance,
disconnect the negative battery
terminal. For details refer to .
|
Ensure that the negative battery terminal is
disconnected.
|
![](../../../img/54/AC312553BW00ENG.png)
|
(4)Continuity between A-07 joint
connector (CAN1) terminal No.2 and A-03 ABS-ECU connector
terminal No.21 OK: 2 ohms or less
|
![](../../../img/54/AC312553BZ00ENG.png)
|
(5)Continuity between A-07 joint
connector (CAN1) terminal No.5 and A-03 ABS-ECU connector
terminal No.23 OK: 2 ohms or less
caution |
Strictly observe the specified
wiring harness repair procedure.
For details refer to .
|
Q.
Are the check results normal?
<All the
resistances measure 2 Ω or less> Power supply
to the ABS-ECU may be suspected. Diagnose the ABS system.
Refer to .
<Either or all
of the resistances measure more than 2 Ω> Repair
the wiring harness between the joint connector (CAN1) and
the ABS-ECU connector.
|