![](../../../img/54/AC313396AS00ENG.png)
![](../../../img/54/AC313400AF00ENG.png)
|
caution |
The strand end of the twist
wire should be within 10 cm from
the connector. For details refer to .
|
|
![](../../../img/54/AC209350AB00ENG.png)
|
When checking the joint connector,
ensure that its wiring harness side and its short pins
are not damaged.
Q.
Is the check result normal?
Go to Step
2.
Repair a
defective connector or replace the joint
connector.
|
![](../../../img/54/AC313396AS00ENG.png)
![](../../../img/54/AC313400AF00ENG.png)
|
(1)Disconnect the joint connector
(CAN2) and the ETACS-ECU connector, and measure at the
wiring harness side. (2)Ignition switch: OFF
(LOCK) (3)
caution |
When measuring the resistance,
disconnect the negative battery
terminal. For details refer to .
|
Ensure that the negative battery terminal is
disconnected.
|
![](../../../img/54/AC312553BE00ENG.png)
|
(4)Continuity between C-09 joint
connector (CAN2) terminal No.3 and C-221 ETACS-ECU connector
terminal No.72 OK: 2 ohms or less
|
![](../../../img/54/AC312553BG00ENG.png)
|
(5)Continuity between C-09 joint
connector (CAN2) terminal No.14 and C-221 ETACS-ECU
connector
terminal No.73 OK: 2 ohms or less
caution |
Strictly observe the specified
wiring harness repair procedure.
For details refer to .
|
Q.
Are the check result normal?
<All the
resistances measure 2 Ω
or less>
Power supply
to the ETACS-ECU may be suspected. Diagnose the SWS. Refer
to .
<Either or all
of the voltages measure more than 2 Ω>
Repair
the wiring harness between the joint connector (CAN2) and
the ETACS-ECU connector.
|