INSPECTION PROCEDURE E-3: Encrypted Code cannot be Registered.


caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.


COMMENTS ON TROUBLE SYMPTOM
If the encrypted code registration mode is not entered, the key reminder switch, the hazard warning lamp switch or the ETACS-ECU may be defective.
If the registration is not possible although the registration mode is entered, the keyless entry transmitter or the ETACS-ECU may be defective.

POSSIBLE CAUSES

  • Malfunction of the keyless entry transmitter
  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE

Step 1. Check the encrypted code registration mode.
Check that the encrypted code registration mode is entered.

Q. Is the check result normal?
Go to Step 3 .
Go to Step 2 .

Step 2. ETACS switch data by using the SWS monitor.
Check the relevant ETACS-ECU signal before entering the encrypted code registration mode.

  • Ignition switch: OFF (key inserted)
  • Hazard lamp switch: ON
Item No.
 Item name
 Normal condition
Item 03
 KEY REMIN SW
 OFF
Item 04
 HAZARD LMP SW
 ON (only when switch is operated)
OK: Normal conditions are displayed for all the items.

Q. Are the check result normal?
Normal conditions displayed for all the items : Go to Step 3 .
Normal condition is not displayed for item No.03. : Refer to inspection procedure P-10 "The key reminder switch signal is not received ."
Normal condition is not displayed for item No.04. : Refer to inspection procedure P-11 "The hazard warning lamp switch signal is not received."

Step 3. Use the SWS monitor to examine the keyless entry system for signal reception.
Check the condition of the keyless entry transmitter.
Operation switch
 Normal conditions (received signal)
LOCK
 LOCK
UNLOCK
 UNLOCK
OK: By operating the switch as shown in the table above, relevant normal conditions are displayed.

Q. Are the check result normal?
Go to Step 4 .
Refer to Inspection Procedure P-20 "Each switch signal of the keyless entry transmitter is not received ."

Step 4. Retest the system.
Check that the encrypted code can be registered.

Q. Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.