Diagnosis code
No.01 Trouble in SWS communication line system or ETACS-ECU
|
caution |
If diagnosis code No.01 is
set in the ETACS-ECU, diagnose the CAN bus lines.
|
|
|
The ETACS-ECU communicates with the column
switch, the front-ECU and the sunroof motor
assembly through the SWS communication line. If there is any trouble in the
ETACS-ECU or the
SWS communication lines , diagnosis code No.01 will be set.
|
|
COMMENT ON TROUBLE SYMPTOM
|
|
The wiring harness wire or connectors may have
loose, corroded, or damage terminals, or
terminals pushed back in the connector, or the ETACS-ECU may be
defective.
|
|
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
|
Step 1. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus
lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair
the CAN bus line (Refer to GROUP 54F - Troubleshooting ).
|
|
|
|
Step 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is
set.
|
|
(1)Ignition switch: LOCK (OFF) position to ON
|
|
(2)Erase the diagnosis code.
|
|
(3)On completion, check that the diagnosis code is not
reset.
|
|
Q.
Is the check result normal?
|
|
If a
trouble is solved, it is determined that there is an intermittent
malfunction
such as poor engaged connector(s) or open circuit (Refer to GROUP 00
- How to use troubleshooting/Inspection
Service Points ).
|
|
|
|
Go to Step 3.
|
|
|
|
Step 3. ECU check by using the SWS monitor
|
|
Check that the SWS communication lines are in
good condition.
|
|
ECUS TO BE CHECKED
- Column ECU
- ETACS-ECU
- Front ECU
- Sunroof-ECU
|
|
OK: "OK" are displayed for all the
items
|
|
Q.
Are the check result normal?
|
|
Normal conditions are displayed for all the
items. : Intermittent malfunction (Refer to GROUP 00 - How to Use
Troubleshooting/Inspection
Service Points ).
|
|
|
|
"NG" is displayed on the "COLUMN ECU" menu. :
Refer to Inspection Procedure A-2 "Communication with column switch
(column-ECU)
is impossible ."
|
|
|
|
"NG" is displayed on the "ETACS ECU" menu. :
Refer to Inspection Procedure A-3 "Communication with ETACS-ECU is
impossible ."
|
|
|
|
"NG" is displayed on the "FRONT ECU" menu. :
Refer to Inspection Procedure A-4 "Communication with front-ECU is
impossible ."
|
|
|
|
"NG" is displayed on the "Sunroof ECU" menu. :
Refer to Inspection Procedure A-5 "Communication with sunroof-ECU is
impossible ."
|
|
|