Diagnosis code
No.10 Bus off
|
caution |
If diagnosis code No. 10
is set in the ETACS-ECU, diagnose the CAN bus lines.
|
|
|
caution |
Whenever the ECU is replaced, ensure that the input and output
signal circuits are normal.
|
|
|
Diagnosis code No. 10 will be stored when the ETACS-ECU ceases CAN communication (bus
off) and then resumes the communication by turning the ignition switch to the "LOCK" (OFF) position.
|
|
COMMENTS ON TROUBLE SYMPTOM
|
|
The wiring harness wire or connectors may have loose, corroded, or damage terminals, or
terminals pushed back in the connector, or the SWS communication lines may be defective.
|
|
Damaged harness wires and connectors
|
|
Step 1. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Correct the CAN bus line. (Refer to Group 54F - Diagnosis .)
Repair the CAN bus line and go to Step 3.
|
|
|
|
Step 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition: LOCK (OFF) position to ON
|
|
(3)On completion, check that the diagnosis code is not reset.
|
|
Q.
Is the check result normal?
|
|
If a trouble is solved, it is determined that there is an intermittent malfunction
such as poor engaged connector(s) or open circuit (Refer to GROUP 00 - How to Cope
with Intermittent Malfunction ).
|
|
|
|
Replace the ETACS-ECU, and then go to Step 3.
|
|
|
|
Step 3. Check whether the diagnosis code is reset.
|
|
Recheck if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition switch: LOCK (OFF) position to ON
|
|
(3)Check if the diagnosis code is set.
|
|
Q.
Is the check result satisfactory?
|
|
The procedure is complete.
|
|
|
|
Return to Step 1.
|
|
|