DISASSEMBLY AND REASSEMBLY

			Cooling temperature switch disassembly steps
		1.	Snap ring
		2.	Refrigerant temperature switch
			Magnetic clutch disassembly
	>>D<<	·	Air gap adjustment
<<A>>	>>C<<	3.	Self-locking nut
		4.	Armature
	>>B<<	5.	Snap ring
		6.	Rotor
		7.	Snap ring
	>>A<<	8.	A/C compressor coil
		9.	Shim
		10.	A/C compressor

DISASSEMBLY SERVICE POINT

<<A>> SELF-LOCKING NUT REMOVAL

Use the special tools to remove the self-locking nut.

Special spanner (MB991367)
Pin (MB991386)

REASSEMBLY SERVICE POINTS

>>A<< A/C COMPRESSOR COIL INSTALLATION

Install the A/C compressor coil while aligning the pin hole of A/C compressor itself with the protrusion of A/C compressor coil

>>B<< SNAP RING INSTALLATION

Use the snap ring plier and Install the snap ring so that the taper faces the outside.

>>C<< SELF-LOCKING NUT INSTALLATION

Use the special tool as during removal to secure the armature and tighten the self-locking nut.

>>D<< AIR GAP ADJUSTMENT

Check that the air gap of clutch satisfies the standard value. If not within the standard value, use shims to adjust it.
Standard value: 0.3 - 0.5 mm <Except vehicles for Hong Kong and Singapore>
Standard value: 0.35 - 0.6 mm <Vehicles for Hong Kong and Singapore>