|
1.Before inspection, set the
vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch
to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 -
Precautions Before Service - M.U.T.-III
Sub Assembly ).
|
![](../../../img/11/AKB00562AB00ENG.png)
|
3.Disconnect the ventilation
hose from the positive crankcase ventilation (PCV) valve,
and
then connect a vacuum gauge to the ventilation hose. Plug
the PCV valve. 4.Start the engine and check that
idle speed is approximately 700 r/min <Except
Euro5> or approximately 750 r/min
<Euro5>. 5.Check the inlet manifold
vacuum. Limit: Minimum 60
kPa 6.Turn the ignition switch to the
"LOCK" (OFF) position. 7.Remove the vacuum gauge
and then connect the ventilation hose to the PCV
valve. 8.Disconnect the M.U.T.-III.
|