|
1.Remove the air intake hose
from the throttle body.
|
|
2.Turn the ignition switch
to "ON" position.
|
|
3.Verify that the throttle
opens or closes according to the accelerate pedal
operated.
|
![](../../../img/13/AKB00627AB00ENG.png)
|
1.Disconnect the
electronic-controlled throttle valve
connector. 2.Measure the resistance between
terminals No. 1 and No. 2 at the electronic-controlled
throttle valve connector. Standard value: 0.3
- 100 Ω (at 20°C)
note |
If the measured resistance
deviates from the standard value, fully open the
throttle valve
with your finger more than five times, then
check the result again. If the throttle valve
control
serve is not used for an extended period of
time, the resistance may be increased as a
result
of internal forming of oxide film. Therefore, it
means that the oxide film can be removed through
a self cleaning capability of the throttle valve
control servo, if forcibly moved.
|
3.If resistance is outside the standard
value, replace the throttle body assembly.
|