Code No. P1570: Received Failure Signal from FCM-ECU<Vehicles with FCM-LS>




FUNCTION



note When the signal of the FCM-LS that is being started is continuously received, a diagnosis code may be set. When no diagnosis code is set in the FCM-ECU, the vehicle is in the normal condition.

TROUBLE JUDGEMENT


Check Condition
Judgement Criterion

FAIL-SAFE AND BACKUP FUNCTION




PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnosis.



  • Use M.U.T.-III to perform CAN bus line diagnosis.

Q. Is the check result normal?

Go to Step 2.
Repair CAN bus line (Refer to GROUP 54C - Troubleshooting, CAN Bus Diagnostics Table ). After repairing CAN bus line, go to Step 3.

STEP 2. M.U.T.-III other system diagnosis code.



  • Confirm whether the diagnosis code is set in the FCM-ECU.

Q. Is diagnosis code set?

Perform troubleshooting of the FCM-LS (Refer to GROUP 54A - FCM-LS, Troubleshooting, Diagnosis Code Chart ).
Go to Step 3.

STEP 3. M.U.T.-III diagnosis code.


Check if Diagnosis code(s) other than No. P1570 is set in the engine-ECU

  1. Erase the set diagnosis code.
  2. Ignition switch: "LOCK" (OFF) → "ON"
  3. Confirm whether the diagnosis code is set.

Q. Is diagnosis code set?

Inspection chart for diagnosis code. (Refer to ).
Go to Step 4.

STEP 4. M.U.T.-III diagnosis code.


Confirm again whether the diagnosis code is set in the engine-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: "LOCK" (OFF) → "ON"
  3. Confirm whether the diagnosis code is set.

Q. Is diagnosis code set?

Replace the engine-ECU.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunctions).